Remote Control Features And Settings-Cool Only; Applicable Model - Hotpoint Hw12Hn2Caa Manuel Du Propriétaire

Remote Control Features and Settings-Cooling Only

Applicable Model

MODEL
HW12HN2CAA
AC HW18HN2CAA
HW24HN2CAA
Remote Control
6
8
TURBO
2
COOL DRY
TEMP
11
SWING
5
TEMP
3
ºF/ºC
1 3
TIMER TIMER
ON
1 6
LOCK LIGHT
12
14
1. Power Button
Press the ON/OFF button on the remote control to
start or stop the unit.
2. COOL Button
In COOL mode, the unit operates in cooling. When
FAN is set to AUTO, the heat pump automatically
adjusts the fan speed according to the room
temperature. The will be displayed during COOL
mode.
49-5000885 Rev. 0
1
7
FAN
4
10
SWING
9
ECO
QUIET
15
CONFIRM
OFF CANCEL
18
RESET
1 7
3. Fahrenheit/Celsius Button
Press °F/°C to toggle remote and unit display
temperature between Fahrenheit and Celsius.
4. Temperature +/– Buttons
Temp + : Every time the button is pressed, the
temperature setting increases. Temp – : Every time
the button is pressed, temperature setting decreases.
The operating temperature range is 60°F-86°F
(16°C-30°C).
5. FAN SPEED Button
FAN SPEED: For each press the fan speed changes
as follows:
Remote control:
LOW
6. DRY Button
DRY mode is used to reduce humidity. In DRY mode,
when room temperature becomes lower than temp.
setting +2°F, unit will run intermittently at LOW speed
regardless of FAN setting. The
during DRY mode.
7. FAN MODE Button
FAN mode circulates air only; there is no temperature
adjustment available. Use the fan speed button (5)
to adjust fan speed from low, medium to high. Auto,
Turbo and Quiet are not available. The
displayed during FAN mode.
8. TURBO Button
The TURBO function is used for fastest air flow in
Heating or Cooling modes. Control will display the
TURBO icon on the bottom right side of the
remote display. Pressing the TURBO button again or
the FAN SPEED button will turn TURBO off.
9. Quiet Button
The QUIET function switches the fan to the lowest
speed. The control will display the QUIET icon
the bottom left side of the remote display. Pressing
the QUIET button again or the FAN SPEED button will
turn QUIET off.
Display
circulated
MED HI AUTO
will be displayed
will be
on
3