Hitachi RAK-50PXA Manuel De Fonctionnement page 35

ATTACHING THE AIR PURIFYING FILTERS
CAUTION
Cleaning and maintenance must be carried out when À lter lamp lights. Before cleaning, stop operation
and switch off the power supply.
1
Open the front panel
O
2
Remove the pre-À lter
O
3
Attaching the air purifying À lters
O
4
Attach the pre-À lters
O
O
NOTE
O
In case of removing the air purifying À lters, please follow the above procedures.
O The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying
À lters are used. So, set the fan speed to "HIGH" when using it in this condition.
O Do not operate the air conditioner without pre-À lter. Dust may enter the air conditioner and fault may
occur.
Downloaded from www.Manualslib.com
Pull up the front panel by holding it at both sides with
both hands.
Push upward to release the claws and pull out the
pre-À lter.
Attach the air purifying À lters to the frame by gently
compress its both sides and release after insertion
into pre-À lter frame.
CAUTION
Do not bend the air purifying
À lter as it may cause damage
to the structure.
Please do not smell direct from
source of À lter.
Attach the pre-À lters by ensuring that the surface written
"FRONT" is facing front.
After attaching the pre-À lters, push the front panel at
three arrow portions as shown in À gure and close it.
manuals search engine
Claws
(4 places)
– 9 –