Arctic Cove MAC1217K Manuel D'utilisation page 9

 Ensure tubes and connectors are assembled so that all
the nozzle openings are aimed in the same direction after
twisting.
 Allow at least 1 hour of drying time before connecting
water to the system to prevent leaks or clogging.
MOUNTING THE MISTING KIT
See Figures 9 - 10.
WARNING:
Install hanging mounts in an area where no electrical
wires, utility cables, pipes, or other obstructions are
located. Contact your local utility company or a qualified
electrician if you are unsure. Ensure hanging mounts
and misting kit are securely installed to prevent falling
object or slippery surface hazard. Failure to follow these
instructions can result in electrical shock or other serious
personal injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 when using a hammer to
install the hanging mounts and misting tube. Failure to
do so could result in objects being thrown into your eyes
resulting in possible serious injury.
ASSEMBLY
To obtain the best spray area (mist curtain), we recommend
that the misting tube be secured to an overhead support.
Always mount in a suitable location for the misting kit away
from electrical devices and switches.
When mounting the horizontal section of the misting tube
assembly, be sure to allow a slight downard fall on the side
where the drain valve is located. To help prevent clogged
nozzles and for best drainage when the sytem is not in use,
the drain valve must be installed at the lowest point on the
line.
NOTICE:
If you assemble and cement the complete kit on the
ground before hanging, be sure to get help as needed to
hold the assembled tubes while mounting. Allowing long
sections of pipe to dangle freely can cause them to break.
To mount the misting kit:
 Attach hanging mounts to the PVC pipe between each
section of assembled line.
 Using a hammer, install the hanging mounts and
assembled pipe in the desired location.
NOTE: Be careful not to damage the PVC pipe during
installation.
5 — English