Brita OPFF-100 Guide D'utilisation page 5

STEP 2: Determine if you need to use an adapter.
If your faucet has threads on the outside:
You most likely will not need to use an adapter. Attempt to
attach the system directly to your faucet. If it does not fit,
call Brita Consumer Services at 1-800-24-BRITA (U.S.) or
1-800-387-6940 (Canada). Proceed to Step 3.
If your faucet has threads on the inside:
You will need to use one of the adapters and corresponding
washers provided. Select the proper adapter and washer that
fit onto your faucet. If neither adapter fits, please call Brita
Consumer Services at 1-800-24-BRITA (U.S.) or
1-800-387-6940 (Canada).
Place the washer into the recessed end of the adapter. Twist
the adapter (counterclockwise) onto your faucet and tighten
by hand until snug. If difficult to tighten, insert a coin into
the notch in the bottom of the adapter and twist until snug.
Caution: Using pliers to tighten the adapter may damage the
threading.
NOTE: The Brita
with a built-in spray feature at the end of the faucet.
Side View
Top View
Downloaded from www.Manualslib.com
® Faucet Filtration System cannot be attached to faucets
Mounting Collar
manuals search engine
Threads Outside – Likely No
Threads Inside – Use an Adapter
STEP 3: Attach the base
system to your faucet.
Position the base system
so that the filter cup is on
the left side of your faucet
and the filter replacement
indicator is facing you. Twist
the mounting collar onto the
faucet and tighten by hand
until snug. Do not tighten
with pliers. Do not over-
tighten.
If you are having difficulty,
rotate the base system
backward and forward
while further tightening the
mounting collar.
3
Adapter Needed