MSW Motor Technics S-POWER-P&P7 Manuel D'utilisation page 31

c) Hang the micro-inverter on the screw (as shown on the right) and tighten the screws. Silver cover for
micro inverters should face the panel.
2. AC cable connection method of micro-inverter
a) Connect the AC three-way handshake cable as shown on the right to make two micro-inverters. The
AC terminals are connected to form a continuous AC branch circuit.
b) Connect the three-way handshake of the last micro-inverter in the AC branch circuit. Tighten the AC
end cap on the connection cable.
3. Install the cable
AC three-way Handshake Cable Diagram
a) Components of AC three-way handshake cable:

M16 male (cable size 3*0.75mm²)

M25 female head (cable specification 3*4mm²)

M25 male head (cable specification 3*4mm²)
b) Connect the M25 female end of the tee connector with the M25 male end of another tee connector
to complete the circuit.
EN