cecotec BAMBA PRECISIONCARE PROFILING Manuel D'instructions page 77

WARNING: as not all hairs grow in the same direction, you may
need to use different trimming positions (upwards, downwards or
crosswise).
3. If cut hairs have accumulated on the guide comb, switch off
the appliance, remove the guide comb and clean the hair
from the comb. Once clean, put the guide comb back on and
continue cutting.
Trimming the beard
4. Make sure the guide comb is put back into the appliance and
use the 1mm or 2mm setting for a "stubble" look.
5. When you have finished using the appliance, switch it off by
pressing the on/off button. Then remove the guide comb (Fig.
4) and clean the hairs accumulated in the appliance with the
help of the cleaning brush.
Profiling
• For close trimming of hair or beard, use the appliance without
a guide comb.
• Remove the guide comb for:
• Sideburns trimming (Fig. 5).
• Neck trimming (Fig. 6).
• Beard trimming (Fig. 7).
ENGLISH
BAMBA PRECISIONCARE PROFILING
77