cecotec BAMBA PRECISIONCARE PROFILING Manuel D'instructions page 76

ENGLISH
• If the appliance has not been used for a long time, it must be
fully recharged.
• If the appliance is subjected to a major change in temperature,
pressure or humidity, allow the appliance to acclimatise for
30 minutes before use.
Guide comb Trimming (1 mm, 2 mm, 3 mm, 4 mm)
• The appliance can be used to trim sideburns, neck, beard and
hairlines.
• Make sure that the appliance is switched off.
• Place the guide comb over the blade and press it into the
appliance. Fig. 2
76
BAMBA PRECISIONCARE PROFILING
• When using the appliance, you can insert the protective
cover, which prevents long hair from tangling. Fig. 3
• If you are trimming for the first time, start by using the guide
comb with the maximum trimming length setting (4 mm) to
avoid accidentally trimming hairs that are too short. As you
become familiar with the guide combs, change them by 3 mm,
2 mm and 1 mm until you reach the desired cutting length.
1. Switch on the appliance.
2. For the most effective trimming, move the appliance against
the direction of hair growth. Make sure that the surface of the
guide comb always remains in contact with the skin.