Cleaning And Maintenance; Troubleshooting - Cecotec Toothcare Jet Splash Manuel D'instructions

4. CLEANING AND MAINTENANCE

Before cleaning the appliance, make sure that it is switched off.
Fig. 6.
Remove the water inlet plug. Turn the irrigator upside down to remove all water.
-
Remove the water tank by pulling it and rinse its interior with clean water at room
-
temperature. Do not clean the tank with any type of cleaning agent.
Remove the nozzle and clean it with water.
-
Only use clean water or a neutral cleaning agent to clean the body of the appliance. Do
-
not use abrasive or corrosive products. The temperature of the water used to clean the
appliance must not exceed 50 °C, otherwise the appliance may get damaged.
Do not immerse the body of the appliance in water. If necessary, clean the surface of the
-
appliance with a soft cloth and a little neutral soap.
After cleaning the irrigator, dry all parts thoroughly before storing.
-
Store the appliance in a dry place away from sunlight.
-
Removing limescale deposits
Depending on the mineral content of the water used, limescale deposits may build up in the
appliance. Failure to remove them will reduce the effectiveness of the appliance.
Point the nozzle towards the sink, switch on the appliance and let all the water flow out
-
of the tank.
Fill the water tank with clean, warm water and repeat the previous step to clean the tank.
-
This cleaning process should be repeated every 1-3 months.

5. TROUBLESHOOTING

Problem
There is a water leak
between the nozzle and
the body of the appliance
There is a leak in the
water inlet
There is a leak in the
water tank
Possible causes
The nozzle is not correctly
fitted.
The water inlet is dirty.
The water tank plug is not
correctly positioned.
The tank is not assembled
correctly.
The rubber seal is damaged.
Possible solutions
Fit the nozzle correctly.
Clean the water inlet.
Fit the plug correctly.
Position the tank correctly.
Contact the official Cecotec
Technical Support Service.
TOOTHCARE JET SPLASH
ENGLISH
55