Agri-Fab 45-04561 Manuel Du Propriétaire page 7

21. Secure the upper and lower hopper tubes together
using two 5/16" x 3/4" hex bolts (17) on the inside and
two 5/16" nylock nuts (21) outside. See figure 13.
21
17
22. Install two cotter pins (27) in the rear hopper tube.
Bend ends of cotter pins around tube.
23. Slide the dump handle clip (33) onto the dump tube (5).
24. Place the U-clamp (34) between the cotter pins in
the rear hopper tube. Attach the dump tube (5) to the
U-clamp (34) using a 1/4" x 1-1/2" hex bolt (16) and a
1/4" nylock nut (24). See figure 14.
25. Swivel the dump tube so that the end of the tube
rests on the ground behind the bag and supports the
rear of the bag in an upright position.
33
17
21
FIGURE 13
24
27
5
FIGURE 14
26. Insert the hopper support rods (7) into the hole
beneath the curved head bolt (26) in each upper
hopper tube. Flex and insert the rod into the hole in
the bottom rear hopper tubes as shown in figure 15.
NOTE: The hopper support rods will flex about as much
as shown in figure 15 when they are assembled.
7
27. Slide the pivot rod (2) through the flap in the bag's
windscreen first and then through the hole in each
upper hopper tube. See figure 16.
28. Hammer a palnut (23) onto each end of the pivot rod .
See figure 16.
HINT: Place the bag on its side on a hard surface to make
installation of palnuts easier.
34
16
7
26
7
7
FIGURE 15
2
23
FIGURE 16