Infant Child Restraint Installation; Installing Without Base - Joie juva Manuel D'utilisation

1. Lift the cover of adjustment button.
2. While pressing the adjustment button located at the front of
the infant child restraint, pull completely the two shoulder
harnesses of the infant child restraint.
3. Unlock the buckle of the harnesses by pressing the red
button. (Fig.16)
4. Place child into the infant child restraint and lock the buckle.
(Fig. 17 & 18)
5. Tension the shoulder harnesses by pulling adjustment
webbing. (Fig. 19)
!
Make sure the space between the child and the shoulder
harnesses is about the thickness of one hand.
Infant Child Restraint
Installation
The infant child restraint can be used with the base and certain
joie strollers. The installation instructions vary depending on
whether or not you are using the base or stroller. Please refer
to the proper section.
!
Do not place the infant child restraint on front vehicle seat
with airbag. Death or serious injury can occur.
!
When use the infant child restraint in a vehicle seat, please
adjust the handle to position 1.
!
Face your child restraint or base toward the rear of the
vehicle.
!
Ensure the vehicle safety belt is not slack or twisted.
!
Always fasten the harness of your child restraint securely
on your infant, regardless of how it is being used.
21
(Fig.14)
(Fig. 15)
(Fig. 20)
(Fig. 5.1)
i. Installing without Base
After fitting the harness to your child and determining which
rear vehicle seat location is best, you are ready to install your
infant child restraint.
1. Place the infant child restraint onto the vehicle seat where
you wish to put it, pull the vehicle safety belt and slide the
lap belt into the two side guides of the infant child restraint,
and lock it into the buckle.
! The child restraint can not be used if the vehicle safety
belt buckle (female buckle end) is too long to anchor the
child restraint securely.
2. Slide diagonal belt into the rear guide.
3. Pull the belt to fasten the infant child restraint tightly and
securely. (Fig. 23)
!
Tension the vehicle safety belt as much as possible,
check that it is not loose or twisted.
!
The vehicle safety belt shall not cause pressure on any
part of the child.
Correctly assembled vehicle safety belt is shown as
!
Lap belt must pass through the two side guides,
as Fig. 24.1
!
The vehicle buckle is locked correctly, as
!
Diagonal belt must pass through the rear guide,
as Fig. 24.3
(Fig. 21)
(Fig. 21.1)
(Fig. 22)
Fig. 24
Fig. 24.2
22