Remote Control - Roblin Agate Extreme Manuel D'utilisation

D Short
Long press with
all loads off (mo-
tor and lights)
E Short
Long press with
lights on
Recommended device coupling sequence:
1 - K-Link Mode (See "connected mode" of remote control manual)
2 - K-Link Coupling (See hood manual)
3 - Remote Control-Hood Coupling (See remote control manual)
4 - K-Link Coupling (See hood manual)
5 - Cooktop-Hood Coupling (See induction cooktop manual)

5. REMOTE CONTROL

(OPTIONAL)
6. LIGHTING
• Please contact the Service Depart-
ment to change it ("Please contact
the service department to purchase
it").
14
Turns the anti-condensation ventilation on the pull-out panel on/off.
It is deactivated by pressing the same key or by switching off the mo-
tor.
K-Link coupling
Before starting the procedure follow the specific instructions of the
manuals of the devices to be coupled.
For the remote control, see "connected mode".
Starts the pairing procedure between the hood and compatible K-Link
devices (induction cooktop or remote control). Up to 3 induction cook-
tops can be paired and only one remote control. See the manual of
the devices for details of the operations that need to be performed on
these.
The coupling procedure takes 2 minutes. If no devices are recognised
within this time check that you have previously activated the proced-
ure for the devices to be coupled. The maximum number of linkable
devices may have been reached.
AUTO mode is activated when the Coupled Induction Hob is
switched on. The hood speed is automatically set using the highest
power level present on the hob. When the induction cooktop is turned
off the last activated speed is held for 5 seconds, then speed 1 for 15
minutes. Once the 15 minutes have passed the motor turns off. The
light status does not change.
Switches the lights on/off at maximum intensity.
Turns the lights on/off at medium intensity.
LED D lights up and is
permanently lit together
with the set speed LED.
LEDs A and B flashing:
coupling in progress.
Upon successful com-
pletion of the procedure
LEDs A and B will light
up for 2 seconds.
Fixed.
Fixed.