Initialisation - Ninka Qanto Mode D'emploi

EN

6.8 Initialisation

Before and during initialisation, check and make sure that the safety switch-
es are contacted.
The lifting system is initialised by pressing and holding the button.
It must be kept pressed until the drive reaches the lower end position. As
soon as the drive stops in the lower end position, the button must be re-
leased for 2-3 seconds.
Then the button must be kept pressed for an additional 6-8 sec-
onds. After that, the initialisation procedure is completed. During initialisation,
the trays are lowered by 5 mm and then raised again.
Please do NOT release the button during initialisation.
If the button is released before the procedure has been concluded, the
initialisation procedure is interrupted and must be restarted. If an initialisation
procedure is interrupted, an upward movement of the trays is not possible.
During initialisation, the safety switches must be contacted. If the initialisa-
tion procedure cannot be concluded, the upper tray must be removed and
the two safety switches must be pressed manually during the initialisation
procedure.
16 - EN
Qanto_Id_A5_0000.50 65060_EN 26042018