Use - gourmetmaxx CM-111A Mode D'emploi

EN
Cleaning the device
ATTENTION!
• Before using the device for the fi rst time, be sure to observe the notes in the
chapter "Use".
• Observe the instructions in the chapter "Care and decalcifying the device"
before fi rst cleaning.
• The device has overheat protection that prevents reactivation directly after
the brewing process for reasons of safety. Therefore, wait a few minutes af-
ter the brewing process for the device to cool down before starting another
brewing process.
• When cleaning, do not use any corrosive or abrasive cleaners. They could
damage the surface!
• Clean the permanent fi lter, the permanent fi lter holder and thermo cup with
warm water and a small amount of detergent.
• Thoroughly dry the permanent fi lter, the permanent fi lter holder and the ther-
mo cup.
• Place the permanent fi lter and permanent fi lter holder back in the device
once it is completely dry.
• Before fi rst use, we recommend fi lling the water tank two to three times,
each time allowing the water to circulate (without coffee powder/coffee pad)
in order to rinse out the lines etc. and remove any production residue.
1. Place the device on a dry, level and heat-resistant base.
2. IMPORTANT: Place a cup or similar under the coffee spout before
you connect the device to a socket as the device will begin with the
brewing process right away if the On/Off button switch has been
pushed before the device was connected and the device is connec-
ted to a socket.
3. Fill the water tank with water.
4. Connect the device to a properly installed socket.
5. Press the Power switch.
6. The device will automatically deactivate once the brewing process is
complete.
7. Wait a few minutes before you repeat the cleaning process.

Use

ATTENTION!
• The device has overheat protection that prevents reactivation directly after
the brewing process for reasons of safety. Therefore, wait a few minutes af-
18