2.
Connect the power supply
See the "specifications" section about the characteristics of the power supply.
The device has no ON/OFF switch. It turns-on automatically when power is applied. Check
LEDs PWR1 and PWR2:
PWR1 LED is ON if power supply 1 is ON.
PWR2 LED is ON if power supply 2 is ON.
The Diag LED stays red for around 75 seconds, until the device is fully ready to use. Then
the Diag LED turns green.
3.
Connect the Ethernet cable
Plug the provided Ethernet cable to the LAN1 or LAN2 connector.
Check that the corresponding LAN1 or LAN2 LED turns ON at that point.
Installation example of Airbox/14 :
-
-
3