Dimmer Control - Nicols C 2024 J Notice D'utilisation

JOYSTICK
Joystick settings:
1) Press [RUN/EDIT] and relative indicate light ON to enter PROGRAM status
2) Press [SET X/Y] and LED display ( set: X-Y X:[] Y: [])
3) Press P1-P20 to select scanner. (This step can be skipped if X/Y channel of all scanners is same)
4) Press SA/SB/SC to select correspondent X/Y channel to assign to joystick and then relative yellow indicate led light ON or Press
[DELETE] to cancel wrong setting and set correct channel.
5) Press [SET X/Y] again to save and quit.
Cancel joystick setting:
1) Press [SET X/Y]
2) Press P1-P20 to select scanner. (This step can be skipped if X/Y channel of all scanners is same)
3) Press [DELETE] to clear setting and correspondent yellow led light OFF
4) Press [SET X/Y] again to save change and quit.

DIMMER CONTROL:

Distributed control: In the status of non-programming, press SCAN/LIGHT and the indication light ON to enter dimmer function; Press
SA/SB/SC to select relative dimmer channel. Move sliders of it to change dimmer.
NEW FEATURES:
1. Auto-save last running program when switch off or power off and continue play last running program while switch ON or power ON
again.
2. Play single chase or multi chases in cycle. The indicate led light of CYCLE/SUP OFF means chase run cycle.
3. Multi chases (maximum 8 chases) run at the same time. The indicate led light of CYCLE/SUP ON means multi selected chases run
at the same time.
4. Set different X/Y channel of single scanner.
5. Under auto+ manual mix running modes, release single channel or all channel. Press [MANUAL] and [RELEASE CHANNELS],
select correspondent channel via SA/SB/SC to release it. LCD display will show status of current channel from O to F. Press [CLEAR]
and release all channels. Then LCD display show status of all channel from O to F.
Press [ RELEASE CHANNELS] again to save and quit.
Page 13