Ledvance LINK RDORKlT7BS030UNHD8SC814BLE Manuel D'utilisation page 3

WWW.LEDVANCEUS.COM
Installation Instructions
Figure 1
Figure 4
Prior to installation,
the troffer (lens/lens frame, reflectors/ballast
(Fig. 1) NOTE: Follow all federal and local regulations when disposing of lamps and components.
Install the end plates (A) at each end of the troffer housing by sliding it between the T-grid and the existing troffer housing and
2.
secure them using the supplied #8xI/2" self-drilling screws (D) (Fig. 2)
3. Install the side plates (B) into the slots in the end plates (Fig. 3).
Locate the door assembly body (C) into the keyholes in the end brackets, and then slide the door assembly body
4.
horizontally to the end of slots. (Fig.4)
Hook the safety cables into the holes positioned the end brackets (Fig. 5).
5.
A licensed electrician must wire the door kit in accordance with all National Electrical Code requirements
6.
State and Local requirements
Rotate the door kit up into the troffer body and secure the door assembly by locking the latches riveted on each end of
7.
the assembled door frame. (Fig.6)
mported by
LEDVANCE
4303007
1100 TyronePike
Versailles,KY40383
Figure 2
yhole
Figure 5
Hinges
Figure 4A
Safety cable
disconnect all incoming
covers brackets, lamps/lamp holders). Leave the supply wires and grounding leads.
and regulations.
mporté par
LEDVANCE
5450 ExplorerDrive
Mississauga, OntarioL4W 5N1
Figure 2A
power to the existing fixture.
a 1-800-LIGHTBULB (1-800-544-4828)
w,uv ledvanceUS.com (US& Canada)
LEDVANCE isa registered trademark.
LEOVANCE est unemarque déposée
3
Figure 3
Figure 6
Locking Latch
Figure 5A
Removeexisting hardwarefrom inside
as well as all
LEDVANCE