vitapur VWF4 Mode D'emploi page 6

When not using the water filtration system for more than a week or when going
on vacation, please ensure the lower chamber is full and the filters immersed in
water, as the Universal Replacement Filters will dry out. Always drain out any
residual water when ready to start using it again. If the water filtration system
has not been used for an extended period of time, please replace the Universal
Replacement Filters and wash top and bottom chambers.
Problem
Water is
1. The water filtration system
leaking out
2. The silicone float seal is not
3. Float mechanism is sticking.
4. Water is leaking between upper
Water will 1. Universal Replacement Filters
not filter
GOING AWAY ON VACATION
TROUBLESHOOTING
Possible Cause
is not sitting level or
the float mechanism is
obstructed.
inserted correctly or is not
sealing due to residue or
charcoal particles.
and lower chambers.
are blocked.
Suggested Solution
Make sure the water filtration
system is sitting level on the water
dispenser (make sure the bottle
support collar or the spike has
been removed).
Ensure the silicone float seal is
inserted correctly and any residue
is wiped away.
Inner float is caked with residue.
Remove silicone float seal and
separate inner float. Wipe clean
and re-assemble.
Drain water from dispenser taps
to bring water level in bottom
chamber to max level line. Do not
add water to the upper chamber if
the lower chamber is full.
To release air lock, lift upper
chamber and remove filters. Shake
filters or tap gently on countertop.
Push filter back into upper
chamber.
Filters were not soaked for 15
minutes prior to use. Soak filters.
If blocking persists, replace
with new Vitapur
®
Replacement Filters.
Universal