vitapur VWF4 Mode D'emploi page 5

Filling the Filtration System
CAUTION! Never use water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the
filtration system.
CAUTION! Once the filtration system is placed on the water dispenser it
should fit level and secure. The float mechanism that fits inside the water
dispenser must NEVER be obstructed and be allowed to operate freely!
1. Open the top cover.
2. Pour cold tap water into the upper chamber.
CAUTION – NEVER USE HOT WATER!
3. TO AVOID LEAKING AND/OR OVERFLOWING, DO NOT EXCEED THE
MAX LEVELS.
4. Close the top cover.
5. Add water regularly to ensure the filters are immersed in water at all
times between the "MIN" and "MAX" levels indicated on the lower chamber.
Helpful Tips
1. Keep your water filtration system in a dry place and out of direct sunlight.
2. Your Vitapur
and filter over 450 litres (119 gallons) of water.
3. If the water filtration system has not been used for an extended period of
time, please replace the 3 filters and wash top and bottom chambers.
4. When replacing the Universal Replacement Filters, you should wash and
rinse out the entire water filtration system.
5. Use only Vitapur
VGPF3-C (Canada) or VBF3-3U (USA). Visit www.greenwayhp.com.
OPERATING INSTRUCTIONS
Universal Replacement Filters will last up to 4 months
®
approved Universal Replacement Filters:
®
Vitapur
Replacement Filters:
VGPF3-C or VBF3-3U
Available online at
www.greenwayhp.com
Universal
®