Important - Henry Schein 900-9733 Manuel D'utilisation

Users manual for
S
phygmomanometer
IntrodUctIon:
This blood pressure monitor conforms to the Non-inva-
sive sphygmomanometers – Part 1: requirements and
test methods for non-automated measurement type
(ANSI/AAMI/ISO 81060-1:2007), as well as to the Non-
invasive sphygmomanometers – Part 2: Clinical valida-
tion of automated measurement type (ANSI/AAMI/ISO
81060-2:2009) and to the Medical electrical equipment –
Part 2-30: Particular requirements for the basic safety and
essential performance of automated noninvasive sphyg-
momanometers (ANSI/AAMI/IEC 80601-2-30:2009).
All Calibration testing – at least every two years – , has
to be carried out either by the manufacturers or the
local authorised dealer in accordance with the relevant
distributor directives.

Important:

Keep this unit from being knocked or dropped, and pro-
tect it from dirt and moisture. Care has to be taken not to
puncture the cuff with any sharp instruments (Scissors,
Needles). Do not inflate to above 300 mmHg !
Measurement time should be ca. 2 minutes maximum.
Between 2 measurements allow an interval of at least
2 minutes.
Please use only Henry Schein cuffs.
placIng the cUff:
Place cuff in such a manner that the lower cuff edge
finishes ca. 2 – 3 cm above the elbow and the centre
of the rubber bag rests on top of the artery.