LENCO MC-020 Guide D'utilisation page 7

- The alarm icon (Alarm 2) appears and the TIME display is blinking.
- Repeat same step as alarm 1 in order to set Alarm 2.
To select which of the 2 alarms should be active, press the ALARM SET button repeatedly while the unit is in
standby mode (clock display). The display will show consecutively the Alarm 1 icon, the Alarm 2 icon, the
both Alarm icons. Press the ALARM SET button once again to deactivate the alarms (no alarm icon will be
displayed).
SNOOZE FUNCTION
If you want to snooze a few more minutes press the SNOOZE BUTTON will deactivate the sound for
approximately 9 minutes.
SHUT OFF ALARM:
When alarm goes off, press the STANDBY BUTTON to turn off alarm, the alarm will reset until the next day
SLEEP FUNCTION
- In standby on mode
- Press the button (2) to the desired source.
- Press and hold the SLEEP button (9). The "90" will appear on the display.
- Repeatedly press the SLEEP button (9) for desired sleep time between 90, 80, 70, 60, 50, 40, 30, 20 and 10
minutes.
- The unit will automatically switch off when the SLEEP time expires.
- To turn sleep mode off, press the SLEEP button (9) until "OFF" is displayed.
RADIO OPERATION
- Press the STANDBY button (2) until the frequency shown on the display
How to use the buttons for radio
- Press the backward (7) or forward (8) button to search for desired frequency.
Automatic Tuning
- Press & hold the backward (7) or forward (8) button until the display frequency starts run
- When a station of sufficient strength has been found Tuning will stop or you can stop the automatic tuning
by pressing backward (7) or forward (8) button.
- To turn off the radio, Press and hold the STANDBY (2) button.
UNIVERSAL SERIAL BUS PORT FUNCTION (USB) to listen
- Press the STANDBY (2) button until USB icon shown on the display
- Connect USB disk into the USB (11) port of the system.
- The USB disk will play automatically
- Press the PLAY/PAUSE again to stop playing temporarily Resume normal play by pressing the PLAY/PAUSE
button again.
- To stop playback, press and hold the STOP (3) button. The total number of tracks will be shown on the
display.
- To turn off the unit, Press and hold the STANDBY (2) button.
AUX INPUT JACK
- Press the STANDBY (2) button until AUX icon shown on the display
- Connect the AUX connect wire from the out jack of your Personal Player such as portable MP3 player to
the AUX input jack.
- Play Start from your Personal Player and adjust the volume
7