LENCO MC-020 Guide D'utilisation page 6

17. Batteries compartment
18. Stand auxiliary peripheral
Installing batteries
(Backup for the clock in case of a power outage)
- Open the battery compartment on the back of the appliance (17).
- Insert 2 LR3 1.5V batteries, respecting the indicated polarity.
- Close the battery compartment.
Installing the product
- Install the stand on the top of the sound station
- Connect the speakers to the sound station by plugging the sockets inside jacks (12) and (13)
- Connect the plug of the mains voltage adaptor into the socket (14). Plug the other end of the mains
adaptor into a mains socket.
- Only use the adaptor supplied. If another adaptor is used, first make sure that it has identical
specifications.
Standby/Function button
- Press and hold the button (2) to start up device and select a mode.
- To stop the device, press and hold the button (2).
Note: The last active mode before the stop of device is selected by default in starting up.
To set Volume
Press the buttons (5) and (6) to adjust the sound volume from 0 to 16.
TO SET THE CLOCK TIME
In STANDBY OFF mode, Press and hold the button (9), the digital will blink on the display, then
- Press (7) button to set the DESIRED HOUR,
- Press (8) button to set the DSIRED MINUTE. Then press TIME SET button to confirm.
TO SET ALARM FUNCTION
In Standby off mode
- Press and hold the button (6), icon "AL 1" and the TIME display will blink.
- Press (7) button to set the DESIRED HOUR,
- Press (8) button to set the DESIRED MINUTE.
- After setting the alarm time as you desired, to press ALARM SET button again. You can now select whether
the alarm should go on to Buzzer, Radio or USB
Wake with buzzer
Press the / button until "bb" icon is shown in the display, the buzzer sound will start at the set alarm
time.
Wake with Radio
Press the / button until the frequency is shown in the display. At the set time the alarm will go on at
the radio station you last listened to.
Wake with USB
Press the / button until the "USB" icon is shown in the display. This feature only works when you
have a USB disk inserted in the USB port (11). This USB will be played at the set alarm time
- Press the ALARM SET button again to confirm your settings for Alarm 1.
6