Hope CHAINRINGS 4 Bolt 104 PCD Mode D'emploi

BOLT ON OVAL CHAINRINGS
4 Bolt 104 PCO
O
BOLT ON CHAINRINGS
4 Bolt 96/104 PCD
5 Bolt 110 PCO
O
INSTALLATION
001 Install the chainring
chainring bolt counterbore
the 30T Chainring doesn't
so make sure the engraved
002 For the Oval Chainring,
position align the little tab with
For 4 Bolt Chainrings, align
the crank arm 5 Bolt chainrings
specific angular position
003 Make sure the chainring
length to ensure enough
too long which could prevent
In a cross pattern, tighten
Traduction Franqaise
Deutsche Ubersetzung
so the engraved writing
is facing inward. Note
have ang counterbore
writing is facing inward
to ensure correct
the crank arm.
the bigger pocket with
don't have ang
bolts are the correct
thread engagement or not
proper tightening
the four or five chainring
HOPETECH.COM
o
and bolts to manufacturer
(usually 10-12
that
004 Make
to the spider.
is any, it is verg
are too long.
NOTE: After
to minimise
adjust the chainline_
cogs used on the
we recommend
the chainring
Align with crank arm.
Writing facing inward
recommended
N.m for steel chainring
sure the chainring seats
There should be no plag at all. If there
likely that the chainring
re installing your crankset
the chainring wear you
This depends On the range
rear but to adjust
inserting some shims
and crankset spider
BOLT ON CHAINRINGS
o
Align tab with
crank arm
z
12
torque
bolts)
perfectly flush
bolts used
and chain,
mag need to
Of
the chainline
between