Lorell 34324 Instructions De Montage

Cam Lock Klix Cam
4Pcs + 2 extra Pcs 4Pcs + 2 extra Pcs
STEPI
Apply to al
four positions
0
o
—D
O
STEP3
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched
• Check to make sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packaging straps before your start to assemble.
• Do not tighten all screws/bolts
• Keep all hardware parts out of children's reach.
• It is recommended for 2 persons to complete this assembly.
Dowel Adjustable Glide
2Pcs + 2 extra Pcs 2Pcs
Use Cam Cover (l) to cover
Klix Cam (B)
as shown
Install two each dowels
provided on underside
IMPORTANT :
FUNCTION OF KLIX CAM
Y,IAKE SURE THE ARROW IS
POINTING UPWARDS
BEFORE INSERTING INTO
THE PANEL' S HOLE.
until pieces are completely assembled.
6 Hole L-Bracket Screw #4 x 5/8"
2Pcs 12Pcs + 2 extra Pcs
O
in holes
of worksurface
1/4 RIGHT
TURN FOR
LOCKING
60mm Black
Grommet
Flat Bracket
2Pcs 4Pcs 4Pcs
It is easier if the four each
Flat Bracket (G) are attached
to the desk and
units rather than the
bridge unit first.
0
Install four each Screw (F) in each
L-Bracket. Install two L-Brackets
R3/07
Bridge Unit
34324/34325
Cam Cover Screw M6 x 20mm
+ 2 extra Pcs 24Pcs
STEP2
credenza
O
nvo PEOPLE ARE REOulRE0 TO
ASSEMBLE AND MOVE THIS MODEL