Extreme Max 5600.3256 Instructions D'installation

-naäuC7$
Warning:
Risk of personal injury or property
in a sudden release of the winch
winch manufacturer's instructions
Includes:
1. Winch Mount x 1
2. Fairlead Bracket x I
3. Fairlead Adapter Bracket
4. 3/8" x 1" Flanged Hex Bolt x 6
5. 3/8" Flat Washer x 6
6. 3/8" Lock Nutx 8
7. 3/8" x 1-1/4" Carriage Bolt x 2
8. 5/16" x I" Flanged Hex Bolt x 2
9. 5/16" Flat Washer x 2
10. 5/16" Lock Nut x 2
Not Included:
1. Winch
2. Roller Fairlead
Prior to Installation:
1. Turn off vehicle and lock
2. Locate the battery compartment.
cables.
Installation Instructions
1. Locate and remove the two Torx screws found on the UTV's top grill. Remove the grill and set aside.
Locate and remove the two Torx screws found in the U TV's center grill. Remove the grill and set aside. This grill will
2.
not be re-installed.
3. Locate and remove the three
4. Remove the bolt that mounts
bumper from the UT V.
5. Install the winch onto the winch
• Note: For installations
patterns. the fairlead
patterns. the fairlead
6. Insert the entire winch mount assembly
the mounting holes in the U TV frame. Secure the assembly
nut through all six aligned
7. Place the fairlead bracket and fairlead
feeding the winch cable through
8. Using the hardware provided
on the winch mount.
9. Once the fairlead is in place. tighten
10. Place the UTV's front bumper
II. Place the UTV's top grill back into its original
12. Follow the winch manufacturer's
Customer Service: service@extrememax.com
Winch Mount for Polaris@ Ranger
damage. An improperly
mount and/or winch from
for proper mounting
x I
the brakes.
Remove the ground terminal.
hex head bolts at the
the front bumper to the rest of the frame on both sides of the UT V. Remove the front
plate as directed in the winch
using standard 3.100" two-hole
adapter bracket will be used. For installations
adapter bracket will not be used.
into the frame of the UT V. aligning
mounting holes. Do not tighten
adapter bracket (if required)
the opening.
with the fairlead. secure the roller fairlead
all hardware use to this point of the installation.
into its original position
position
recommendations
mounted winch may result
the ATV frame. Follow
and use of your winch.
then the positive
bottom of the U TV's front end.
manufacturer's
mounting patterns
the mounting
in place using a 3/8" bolt. 3/8" flat washer. and 3/8" lock
at this time.
into position
to the fairlead
and attach it with its original
and attach it with its original
for wiring the winch to power.
I www.extrememax.com
Part # 5600.3256
style # 101560
all
terminal to disconnect the battery
instructions.
or standard 3.00" x 4.875" four-hole
using wide 3.00" x 6.00" four-hole
holes in the winch
from the front of the UTV while
bracket and to the fairlead
hardware.
hardware.
mount to
tab
3399ex0120