afx light DD4 Manuel D'utilisation page 3

INSTRUCTIONS
The unit has one input and four outputs.
The in- and outputs are fully electrically isolated.
DMX connector (3pin) for 4 individual channels,
Each DMX output features an independent driver and DATA+ & DATA- LED indicator.
We strongly recommend that you take some time to read this manual fully before using the DMX distributor.
DMX input: from the DMX controller
DMX output: connect to the DMX receiving device
CONNECTION
Connector pin designations shall be as follows:
pin1: signal common (shield)
pin2: data (-)
pin3: data (+)
1- Receiver cannot more than 31 units before DMX Distributor.
2- Receiver cannot more than 32 units on one output of the DMX Distributor.
3- Use a terminator on the last receiver
© Copyright LOTRONIC 2018
with a 120Ω resistor between the pin 2 and pin 3 of the XLR connector:
DD4 Page 3