Operation; Line Finishing Accessories; Drums - Walter LINE-MATE III Guide De L'utilisateur

OPERATION

Please be sure to read and observe the "SAFETY INSTRUCTIONS" at
the beginning of this manual.
Always use the recommended safety guards when working with this power
tool.
Use only WALTER accessories with a maximum diameter of 7" and a
maximum safe operating speed of at least 4,500 RPM.
The use of any accessories and tooling other than those recommended may
be hazardous. Inspect all accessories and tooling before using. Do not use
any that may be damaged.
Screw all mounted accessories onto spindle and secure firmly with a
spanner.
For maximum performance and best efficiency, apply a steady and even
pressure. Do not use excessive force. Always wear eye protection.
LINE FINISHING ACCESSORIES
PNEUMATIC DRUMS
Width Dia. Arbor
5 3/8" 3 1/2" 5/8"-11
3 1/2" 5" 5/8"-11
Replacement rubber bladder assemblies
5 3/8" x 3 1/2" (for drum 07-F 051)
3 1/2" x 5" (for drum 07-F 037)
Replacement valve for all drums
The pneumatic drums will accept either COOLCUT™ or BLENDEX™ Drum
Belts.
The inflatable bladder conforms to the work piece for a more positive
surface contact.
Mounting Pneumatic Drums
Screw drum onto spindle and secure firmly. Once secured in place, the
pneumatic drum is ready to accept either COOLCUT ™ or BLENDEX™
drum belts.
Max. RPM Order No.
3,800 07-F 051
3,800 07-F 037
07-F 095
07-F 093
07-F 010
12
Mounting Drum Belts
First, deflate bladder and check for a directional arrow on the inside of
the drum belt and match it with the arrow located on the outside flange of
the pneumatic drum. Slip on the selected drum belt and center it over the
drum. To secure belt, inflate bladder by applying air source to valve stem.
Inflate until drum belt feels snug, without over-inflating.
NOTE: a) Do not inflate bladder above 15 psi.
b) When using shop air, be sure to use an approved blow-
gun
equipped with a safety nozzle.
COOLCUT ™ Drum Belts
These belts are made with premium zirconium and aluminum oxide
abrasive grains that are resin bonded to a heavy-duty cotton cloth. The
result is a cool aggressive rate of cut. Excellent for creating or restoring
line finishes, matching mill finishes and levelling small welds. These belts
are well suited as a starting point for further surface refinement.
Width Length Grit
3 1/2" 15 1/2" 40
3 1/2" 15 1/2" 60
3 1/2" 15 1/2" 80
3 1/2" 15 1/2" 120
5 3/8" 11 5/8" 40
5 3/8" 11 5/8" 60
5 3/8" 11 5/8" 80
5 3/8" 11 5/8" 120
NOTE: Prior to mounting the drum belt, verify that the directional arrow on the
inside of the drum belt matches the arrow located on the outside flange of the
pneumatic drum.
Order No.
07-F 364
07-F 366
07-F 368
07-F 371
07-F 504
07-F 506
07-F 508
07-F 511
13