LiftMaster 811LM Mode D'emploi

Life Maseer
Introduction
This product is for use with models 850LM and
860LM universal receivers as well as any
SecuritY+2.00 compatible LiftMaster gate
operators. Depending on the receiver channel,
you may program up to 20 or 50 remote control
dip switch configurations to your receiver. To
exceed the 20/50 limit, match the dip switches
in the new remote control to the dip switches in
an existing remote control.
O
8111M
WARNING:This product can expose you to chemicals including lead, which are known to
the State of California to cause cancer or birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov
Set the Dip Switches
1 Slide the cover open to access the dip
switches in the remote control.
2 Usea pen or screwdriver to slide the dip
switches to any position you want (ON or
OFF).
Programming
1 Press and release the Learn button for the
selected channel on the receiver. The
corresponding LEDwill glow steadily for 30
seconds.
2 Within 30 seconds press and hold the button
on the remote control that you wish to
program to the receiver.
3 Release the remote control
LED on the receiver blinks, then turns off.
Programming is complete.
Repeatthe steps above for each remote control
you would like to program.
If you would like to program an 813LM as an
OPEN,CLOSE,STOP, refer to the 8501M
receiver manual.
o
813LM
button when the
GATE KEY REMOTE
MODELS
WARNING
To prevent possible SERIOUSINJURYor
DEATHfrom a moving gate or garage door:
• ALWAYSkeep remote controls out of
reach of children. NEVERpermit children
to operate, or play with remote control
transmitters.
Activate gate or door ONLYwhen it can be
•
seen clearly, is properly adjusted, and
there are no obstructions
• ALWAYSkeep gate or garage door in sight
until completely closed. NEVERpermit
anyone to cross path of moving gate or
door.
For programming to the 8601M receiver or to a
SecuritY+2.00 compatible gate operator, please
refer to the receiver/operator instructions manual
for location of the learn button(s).
CONTROLS
81 ILM AND 813LM
to door travel.
O
Learn Buttons