Get Started; Connect - Philips Tae8005 Mode D'emploi

3 Get started

Caution
•
Make sure that you have read the safety instructions in
the 'Important safety instructions' section before you
connect and install your stethoscope.

Connect

1. Connect the audio device
Note
•
station automatically turns off.
•
The energizing docking station does not transmit audio
signal when charging.
•
You can charge one stethoscope each time.
See the following instructions to connect the
audio device and adjust ATT.
For TV or other devices with 3.5mm audio
• connect one side of the supplied 3.5mm
audio cable to the 3.5mm audio input of
the docking station and another side to the
3.5mm audio output.
switch to AUDIO IN.
•
switch ATT to 0dB (switch to -8dB if the
•
sound volume is too high).
• connect one side of the supplied RCA
adapter to RCA output of the audio device,
and another side to the supplied 3.5mm
audio cable. Connect the remaining side of
the 3.5mm audio cable to the 3.5mm audio
input of the docking station.
switch to AUDIO IN and ATT to -8dB.
•
• connect one side of the supplied optical
cable to optical output of the device, and
another side to the optical input of the
docking station.
• switch to OPTICAL IN.
• make sure that the audio device is set to
PCM (check the manual of your audio
device for information).
PCM
L
R
EN
5