Hisense RB17N6AWE/L Mode D'emploi page 12

11
Cleaning and care
For hygienic reasons
(including exterior
accessories) should
regularly at least every two months.
Caution! The appliance
connected to the main
to avoid potential electrical
cleaning, please switch off the appliance
off and remove the plug from the main
socket.
Exterior cleaning
To maintain good appearance of your
appliance,you should clean it regularly.
-Wipe the digital panel and display
panel with a clean, soft cloth.
-Spray water onto the cleaning cloth
instead of spraying
surface of the appliance.
ensure an even distribution
to the surface.
-Clean the doors, handles
surfaces with a mild detergent
then wipe dry with a soft cloth.
Caution!
-Don't use sharp objects as they are
likely to scratch the surface.
-Don't use Thinner,
Clorox, ethereal oil, abrasive
or organic solvent such as Benzene for
cleaning. They may
surface of the appliance
cause fire.
Interior cleaning
You should clean the appliance
regularly. It will be easier to clean
when food stocks are low. Wipe the
inside of the fridge freezer with a weak
solution of bicarbonate
then rinse with warm water using a
wrung-out sponge
completely dry before putting the
shelves and baskets
Thoroughly dry all
removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on
the appliance
and interior
be cleaned
must not be
during cleaning
shock. Before
directly on the
This helps
of moisture
and cabinet
and
Car detergent,
cleansers
damage the
and may
interior
of soda, and
or cloth. Wipe
back.
surfaces and
Hisense
the freezer compartment's
if the freezer door is opened frequently
or kept open too long. If the frost is too
thick, choose a time when the supply of
food stocks are low and proceed
follows:
1.Remove existing food and
accessories baskets,
appliance from the mains power and
leave the doors open.
room thoroughly
thawing process.
2. When defrosting is completed, clean
your freezer as described
Caution! Don't use sharp objects to
remove frost from
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back
into the mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet
you open the door. Wash seal with a
mild detergent and warm water. Rinse
and dry it thoroughly after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning! If the LED light is
damaged,
contact
helpline for assistance. To replace the
LED light, the below
followed:
I. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover
and pull it with the other hand while
pressing the connector latch.
4. Replace LED
correctly in place.
interior walls
as
unplug the
Ventilate the
to accelerate the
above.
the freezer
and tear when
the customer
steps can be
with one hand
light and snap it