Mounting Procedure - Webasto Smartemp Control 3.0 Manuel D'installation

SmarTemp Control 3.0
Thank you for choosing Webasto to meet your heating needs. The Webasto SmarTemp Control 3.0
enables you to quickly and effortlessly operate Webasto air and coolant heaters specified in the
compatibility section.
NOTE: The information in this document refers to both the SmarTemp Control 3.0 and SmarTemp
Control 3.0 Bluetooth unless otherwise noted.
Operation
The Webasto SmarTemp Control 3.0 is the next generation of the SmarTemp series controllers. It's
operated using a single rotary dial around the outside of the unit to scroll through menu options.
Simply click the select button to make your choice. Refer to LCD Screen Symbol Legend on page 5 for
more information.
Compatibility
AT 2000 STC – Rheostat to SmarTemp 3.0 Bluetooth Adapter harness (P/N: 5013929B)
AT EVO 40/55 – Rheostat to SmarTemp 3.0 Bluetooth Adapter harness (P/N: 5013930A)
AT 2000STC & EVO 40/55 – SmarTemp 2.0 to SmarTemp 3.0 Adapter harness (P/N: 5013931A)
Thermo Pro 50 & Thermo Top Evo – Rocker switch to SmarTemp 3.0
Bluetooth Adapter harness (P/N: 5013932A)

Mounting Procedure

Multiple factors such as doors and windows must be taken into
consideration as they can directly affect the SmarTemp Controls
ambient temperature reading. Refer to "Temperature Calibration"
section on page 4 if these obstacles are unavoidable.
1. Find a suitable mounting location (on a flat surface if possible) in
a visible area.
CAUTION: The SmarTemp unit must not be mounted within 7.9
in (20 cm) from occupants.
CAUTION: Always install the unit in an area protected from the effects of weather and dust
contamination or the unit will not function as intended.
2. Use the drilling dimensions / template in the back of this manual to lightly mark the two
mounting holes.
3. (Optional Step) To route wire harness through the mounting surface, drill a 17mm hole as
notated on the drilling
dimensions / template.
Note: Always make sure there are no obstacles behind the mounting location prior to drilling.
4. Secure the Webasto SmarTemp Control 3.0 using the two supplied #4 screws.
General
Affix this sticker in a readily visible location in such a way
the operator will be aware of the potential hazard.
2
Installation - Operating Instructions