Digital 7100R Série Guide D'installation page 12

10
Creating server utility and device driver diskettes
If desired, you can create the required diskettes from
Windows-based workstations using these procedures:
1. Locate the Quick Launch CD-ROM disc in your Server-
WORKS software kit. Insert the CD-ROM disc into the
CD-ROM drive.
2. From the Start Menu, select Run qlaunch.exe from the
root directory of the CD-ROM disc. The program will
start automatically if Windows 95 or Windows NT V4.0
and greater are installed.
3. Select the Installations & Utilities button.
4. Choose either the Create Diskettes tab or the Utilities
tab. Utilities is the default. If you choose Create Disk-
ettes, first select a model, then a network operating
system and its version. Select Continue. If you choose
Utilities, select a server model to see the utilities for
that server.
5. Select the utility or driver you want, then select
Continue.
6. Insert a formatted, high density diskette into Drive A
and select Continue.
NOTE
For more information, refer to the ServerWORKS Quick
Launch Getting Started guide and the on-line help in the
ServerWORKS Quick Launch program.
12
The following is a list of device drivers you might need:
SCSI—enables your server to operate using the factory-
installed Adaptec SCSI adapter.
Video—enables your server to operate using the on-
board video controller or other supported video cards.
RAID—enables your server to operate using a Mylex
RAID controller.
Network—choose from several device drivers for
DIGITAL supported network interface cards.
The following is a list of bootable server utilities:
SCU—enables you to make a bootable SCU diskette for
use when configuring your server and adding options.
RAID—enables you to make a bootable RAID configura-
tion utility diskette for use when configuring your
RAID array.
Diagnostics—enables you to make bootable diskettes
for use when troubleshooting your server.
DIGITAL Server 7100R Series