Connecting Wires To Terminals - Kenwood KRC-609 Mode D'emploi

Connecting Wires to Terminals

2WARNING
If you connect the ignition wire (red) and the battery
wire (yellow) to the car chassis (ground), you may
cause a short circuit, that in turn may start a fire.
Always connect those wires to the power source
running through the fuse box.
2CAUTION
When only two speakers are being connected to the
system, connect the connectors either to both the
front output terminals or to both the rear output
terminals (do not mix front and rear). For example, if
you connect the + connector of the left speaker to a
front output terminal, do not connect the - connector
to a rear output terminal.
If no connections are made, do not let the wire come out from the tab.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
To car light control switch
Car fuse
box
(Main fuse)
Battery
Rear left output (White)
Rear right output (Red)
FM/AM antenna input
ANT.
Motor antenna control wire (Blue)
CONT.
film-type antenna.
P.CONT
Power control/Motor antenna control wire
(Blue/White)
Dimmer control wire (Orange / White)
ILLUMI
Ignition key
switch
+ –
Front left output (White)
Wiring harness
(Accessory1)
ACC
Ignition wire (Red)
Car fuse box
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
— 25 —
Front right output (Red)
To KENWOOD disc changer/
DAB control input/
KPA-SD100/KPA-HD100/KPA-
SS100
NOTE
To connect these leads, refer to the
relevant instruction manuals.
Fuse (10A)
White/Black
To front left
speaker
+
FRONT • L
White
Gray/Black
To front right
speaker
+
FRONT • R
Gray
Green/Black
To rear left
speaker
REAR • L +
Green
Purple/Black
To rear right
speaker
REAR • R
+
Purple