Installing A The Cdp3 Into A Pas100 Portable Amplified Speaker - KLEIN+HUMMEL CDP3 Mode D'emploi

DC IN 12V Power connector

Installing a the CDP3 into a PAS100 portable amplified speaker

A CDP3 player may be installed in either or both of the two universal option slots.
Remove the four screws holding one of the blank plates in position (A).
Attach the two rack ears which shipped with the PAS 100 (located inside the option slot behind the blank plate) to the
CD player with two screws on each side (B).
Unwrap the two cables inside the slot labelled for either the top slot or the bottom slot as appropriate. Plug the DC
connector into the DC jack of the CD player (C).
Plug the Audio connector into the Unbalanced Out of the CD Player (C).
Insert the CD PLayer into the option slot (D).
Find the plate with the oval hole cut-out from in the included accessory kit. Re-install the four screws into the new
cover plate with the hole cut-out (D).
Operating Manual CDP3
7 of 40
Page Version 03