Inakustik PREMIUM HDMI SPLITTER 4K Mode D'emploi page 13

ATTENTIONS
• The Audio detection mode will depend on the Minimum or Maximum of the sequent display devices that
can successfully communicate with source device. Make sure your display devices can support the highest
Audio Format as source device can support, and your display devices are HDCP compliant and fully support
HDCP.
• To reset the HDMI Splitter, please unplug the power adaptor, or unplug the power cord from DC jack;
and then plug it back.
TROUBLE SHOOTING
1. When there is no picture presented, please:
• Make sure the direct connection from the source device to the display device without the HDMI
Splitter is working.
• Check if the HDMI cables are high speed supported. (For resolution up to 1080p and 4K×2K,
high speed HDMI cables are required.)
• Check all the connection is correct and all connectors are connected well.
• Check the quality of connected cable, and make sure the cable does not damage.
• Change the connection sequence of display devices.
• Reset the HDMI Splitter.
2. How to make sure your input and output devices are suitable with the HDMI Splitter?
• Whether all devices are HDCP compliant?
• Whether all HDMI cables stay in good quality as well as connectors?
• Make sure all HD displays can support the resolution format.
3. When there is only picture displayed and without sound:
• Check all the connection is correct and all connectors connect well.
• Check your cable to see if it supports video transmission only or it is damaged.
• HDCP may not match very well at first connection. Please reset your HDMI Splitter.
• Do you connect any recorder that does not support HDCP to the output port of HDMI Splitter?
HDCP may lock up audio part.
4. When 3D content could not be shown on your display:
• Please make sure your source and displays are 3D supported devices and also support the
same 3D format.
• Please check the play mode of Blue-ray player has been set 3D mode or AUTO mode for video
output.
• Please make sure the video content is 3D content.
5. If the presented picture is symmetric, which showed with up and down or right and left symmetric image:
• please check whether the TV or projector supports 3D display function and make sure the
function is enabled. If the TV or projector does not support 3D video format, please turn off the
3D play mode of 3D Blue-ray player.
OPER ATION MANUAL PREMIUM HDMI SPLIT TER 1>2 | UP-/DOWN-SC ALER 4K | 3D
13