Connection And Operation - Inakustik PREMIUM HDMI SPLITTER 4K Mode D'emploi

OPER ATION MANUAL PREMIUM HDMI SPLIT TER 1>2 | UP-/DOWN-SC ALER 4K | 3D

CONNECTION AND OPERATION

1. Connect the HDMI cable from the HD source to the input port of HDMI Splitter.
2. Connect the HDMI cables from your displays (monitor or projector) to the outputs of the HDMI Splitter.
3. Select one of the detection modes. Please refer to QUICK DETECTION MODE SELECTION below.
4. Plug the 5VDC power supply into the HDMI Splitter.
5. When connections are completed, the HD signal will be distributed to each HDTV display.
To make sure that the splitter functions properly after installation or after swapping the HDMI cables, it should
be restarted. To do this, briefly disconnect the splitter from the power supply.
Supports 3D video format:
Frame Packing:
Side-by-Side (half):
Top-and-bottom:
QUICK DETECTION MODE SELECTION
DETECTION MODE
A
The smaller audio
format is selected
B
The larger audio
format is selected
12
1920 x 1080p bei 23,98/24 Hz
1280 x 720p bei 59,94/60 Hz
1280 x 720p bei 50 Hz
1920 x 1080i bei 59,94/60 Hz
1920 x 1080i bei 50 Hz
1920 x 1080p bei 23,98/24 Hz
1280 x 720p bei 59,94/60 Hz
1280 x 720p bei 50 Hz
HDMI-SPLITTER
SUGGESTED APPLI-
MODE ACTION
CATION
Signal distribution
for example in pubs,
where sound is not so
important
Home cinema use,
for example where
multi-channel audio
playback is
AUTO DETECTION & AUTO ADJUSTMENT
SUPPORTED
The HDMI Splitter will
compare the EDID
information of each sink
device.A Minimum stan-
dard sink device will be
set as the primary sink
device to communicate
with the source device.
The HDMI Splitter will
compare the EDID
information of each
sink device. A Maximum
standard sink device will
be set as the primary
required.
sink device to commu-
nicate with the source
device.
SOURCE
NOT SUPPORTED
The output Audio For-
mat of the source device
need to be set first.
The output Audio For-
mat of the source device
need to be set first.