Duraflame DFH-107-T Manuel D'instruction page 8

2.Hanging the Heater
Attach the heating unit to the mounting bracket. Lift the heater up and into the mounting
bracket. The bracket screws, located on each side of the heating unit, allow the heater
to be attached easily to the mounting bracket. Make sure screws are tightened up after
desired position is located. If the heater is to be tilted, it must be fastened by the wing nut
screw
(see Fig.4). Tighten the bracket screws with a wrench so the unit is securely suspended at
the desired horizontal or vertical angle.
3.Connecting the power
To connect the power to the heater, simply remove the screw from the front of the unit.This
allows the hinged bottom to open, providing access to the electrical wiring and connectors.
Note:Thermostat knob only use for controling temperature, not for power switch.
To adjust the thermostat, turn the thermostat Control Knob,towards maximum to increase
the set ambient temperature and toward minimum to decrease it.
Thermostat Knob
Use Bottom keyhole
slots if heater is to be
tilted down
Wing nut screws to
fasten the desired
location
Note: Pls use the cord grid
to fix the extension cord after
wiring.
Cord Grid
E-7
Remove the screw to open
the door
Fig.4
Fig.5