Product Specification - Duraflame DFH-107-T Manuel D'instruction

THIS UNIT OPERATES ON 240 OR 208 VOLTS AC. IMPROPER INSTALLATION OR
FAILURE TO FOLLOW THE PROCEDURES AS OUTLINED IN THIS MANUAL CAN
RESULT IN SERIOUS ELECTRICAL SHOCK. DISCONNECT ALL POWER FROM
THE HEATER AT THE MAIN SERVICE BOX BEFORE ATTEMPTING TO INSTALL OR
SERVICE THIS UNIT.
ALL ELECTRICAL WIRING MUST CONFORM TO LOCAL ELECTRICAL CODES.
HEATER CIRCUIT MUST BE PROTECTED WITH PROPER FUSES. SEE TABLE 1
ON PAGE 9.
Proper size fuses and circuit breakers in accordance with the national electrical Code.
Note:For certain applications, conduit may be required . Check local electrical codes.
See Tabel 1, page 9.
if you run the wiring in conduit and wish to be able to turn the heater, be sure to
purchase enough flexible conduit to allow the heater to be turned.
Fig. 1
Connectors, cable, and hardware used to wire the Heater

PRODUCT SPECIFICATION

Voltage Frequency
240V~
208V~
Note: Tolerances on all specification: +5%, -10%
WARNING
!
WARNING
!
Wattage
60 Hz
60Hz
5000W
3750W
E-5
Amperage
20.8 A
18.03A