Tecomec Easy Rivet Manuel D'utilisation Et Entretien page 10

23.4 HANDLING AND TRANSPORT
- If you need to transport the rivet spinner, take it off the
bench and put it in packaging that will protect it against
impact.
23.5 DEMOLITION AND DISPOSAL
The machine is to be demolished by qualified personnel
in compliance with current laws in force in the country in
which it is installed.
The symbol (on the rating nameplate) points out that
the product must not be disposed of with normal household
garbage. Contact an authorized tip or your dealer for disposal
instructions.
Before you scrap the rivet spinner, make it unusable
(for example, by cutting the power supply cable).
24. TROUBLE SHOOTING
Follow the instructions given in the "STOPPING"
section before you start to work on the machine.
Problem Probable cause
One of the safety
devices of the
system to which
the machine is
The machine fails
connected has
to start when you
t r i p p e d ( f u s e ,
switch on (switch
circuit breaker
in pos. "1").
etc.)
The machine is not
plugged into the
mains properly.
T h e m a c h i n e
The grinder is not
vibrates abnor-
secured correctly.
mally.
- Contact a skilled technician if you are unable to restore the
correct operating efficiency of the rivet spinner following
the instructions given in this chart.
8
EN
Solution
Reset the safety
device.
I f t h e s a f e t y
s w i t c h t r i p s
again, do not use
the machine, but
contact a Skilled
technician.
Unplug and plug
in again properly.
Check its attach-
ment and, if nec-
essary, tighten the
securing screws
correctly.