Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HYDRUS
Table of content
1.
Installation guide .............................................................16
2.
Transport and storage ......................................................17
3.
Installation / Initial operation .........................................17
4.
Battery power supply (one or two batteries) ...................20
5.
Cable pin assignment .......................................................20
6.
Pulse outputs (open collector) .........................................21
7.
Due date function .............................................................22
8.
Interfaces .........................................................................22
9.
Operation .........................................................................23
10.
Displays ............................................................................25
11.
Open Source Software Notice ..........................................27
12.
isposal ............................................................................27
13.
Declaration of conformity for MID meters .......................27
1.
Installation guide
This guide is intended for trained specialised personnel. For this reason no
basic working steps are included.
The seal on the meter (see fig. IV, pos. 18) must not be dam-
aged!
A damaged seal will result in immediate invalidation of the fac-
tory warranty and calibration/conformity.
The meter must be installed in compliance with the requirements
of EN 14151 and the EC Type Examination Certificate!
The standards for drinking water installations (e.g. DIN 1988)
must be observed!
Medium: Water without additives
The IZAR@MOBILE 2 software is used for readout/parameterisation and
is available online at
https://www.diehl.com/metering/en/support-center/download-center/
-16-
Deutsch
English
Français
Português
Publicité
Chapitres
Table des Matières
