Operation - Bartscher KV 270L Mode D'emploi

•
Place the device in such a manner that there is a minimum of 10 cm between it and
other objects, including walls, in order to ensure proper air circulation.
•
Do not place the device where humidity or temperature are high as the device may
be damaged.
•
Do not drill holes in the device nor mount other objects to it.
•
Do not place any heavy objects on the device.
•
After positioning in appropriate place block the front castors with brakes.
Connection
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
•
If the device has not been transported in a vertical position, wait at least 2 hours for
the coolant to settle before connecting it to a power source.
•
In the event of a power outage or if the device is unplugged, do not reconnect
the device to the power network for at least 5 minutes.
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.

5.3 Operation

•
After unpacking and prior to connection clean the device according to the instructions
from section 6.2 "Cleaning".
•
Connect the device to the single grounded socket.
•
The required values may be set with use of control elements on the back wall of the
device.
- 26 -