Symbols And Their Meaning; Intended Use; General Safety Instructions - Wolfcraft FKS 115 Notice D'utilisation Originale

INTRODUCTION
• PLEASE NOTE: Read all safety and other instructions that have been supplied with the guide bar and the electric tools
to be used. Failing to observe the safety and other instructions may cause electric shocks, fire and/or severe injuries.
• Do keep the operating instructions for future reference in a safe place.

SYMBOLS AND THEIR MEANING

Warning against a general danger
Read the instructions!
Goggles must be worn.
Hearing protection must be worn.

INTENDED USE

• The guide bar FKS 115 complements your hand-held circular saw.
• For precise, straight and long cuts, also for angular cuts.
• For cutting kitchen work tops, doors etc. to size.
• For commercially available hand-held circular saws up to a cutting depth of 66 mm and a maximum base plate
of 200 x 385 mm (Fig. 5).
The user is liable for any damage and accidents caused by using the equipment not for the intended purpose.

GENERAL SAFETY INSTRUCTIONS

• Keep your workplace clean and well lit. Poor housekeeping or unlit working areas may result in accidents.
• Do not work with power tools in an explosive ambience, where flammable liquids are kept and where gas or dust occur.
Power tools will generate sparks which might ignite the dust or vapours.
• Keep children and other persons off your workplace, while using power tools. When getting distracted you can lose the
control over the equipment.
• The plug of the power tool must fit into the socket. The plug must not be tampered with. Do not use adapters together
with grounded power tools. Unmodified plugs and matching sockets will reduce the risk of getting an electric shock.
• Keep power tools out of the rain and away from wetness. Water penetrating into a power tool will heighten the risk of
getting an electric shock.
• When working with a power tool outside, use only extension cords that are suitable for outdoor use. Using an extension
cord that is suitable for outdoor use will reduce the risk of getting an electric shock.
• If it is unavoidable to use a power tool in a wet ambience, use a residual-current circuit-breaker. It will reduce the risk of
getting an electric shock.
• Take care of what you do and handle the power tool with care. Never use a power tool, when you feel tired or when
you are under the influence of drugs of any kind or alcohol. One moment of inat-tentiveness while using the power tool
can cause severe injuries.
• Do wear suitable personal protective clothing and equipment, such as hearing protection, goggles, dust masks while
doing dust-generating jobs as well as protective gloves, when processing rough materials and when changing tools.
• Remove the setting tools or wrenches before switching on the power tool. A tool or wrench at-tached to a rotating part
of the equipment may cause injuries.
• Wear suitable clothes, i.e. no loose garments or jewellery. Keep your hair, clothing and gloves away from rotating parts.
Loose garments, jewellery or long hair may be caught by such rotating parts.
• Do not use power tools with a defective switch. A power tool that can no longer be switched on or off is dangerous and
needs repairing.
• Keep unused power tools out of the reach of children. Do not allow persons using equipment which they are not familiar
with it, or persons who have not read these instructions. Power tools pose a danger, when being used by inexperienced
persons.
t
Dust mask must be worn.
Wear protective gloves.
Pull the plug.
For general information
12