Installation; Installation Configuration; Typical Residential Installation; Typical Commercial Installation - Stiebel Eltron TEMPRA 12 TREND Notice D'utilisation Et Installation

INSTALLATION

INSTALLATION CONFIGURATION
INSTALLATION
6. Installation configuration
The Tempra can be used for the following applications.
6.1

Typical residential installation

6.2

Typical commercial installation

7.

Mounting the unit

NOTICE: Unit must be installed in a vertical position
!
with the water fittings pointing downward.
WARNING: Do not install unit where it would routinely
be splashed with water. Electric shock may result.
CAUTION: Hot water outlet pipes leaving unit can be
hot to the touch. Insulation must be used for hot water
pipes below 36" (0.9 m) due to burn risk to children.
NOTICE: This unit should not be installed in a location
!
where it may be exposed to temperatures less than
36°F (2°C). If the unit may be subject to freezing tem-
peratures all water must be drained from the unit.
Failure to comply with this instruction voids all war-
ranties.
The unit should be located in an area where water
leakage from the unit or connections will not result in
damage to the area adjacent to the unit. If such a loca-
tion cannot be avoided it is recommended that a drain
pan be installed under the unit.
10 | TEMPRA TREND & TEMPRA PLUS
7.1

Mounting dimensions

A
B
C
D
E
Dimensions
A ⅜˝ (10 mm)
B 12½˝ (318 mm)
C 1˝ (26 mm)
D ¾˝ (20 mm)
E 7½˝ (190 mm)
F 7½˝ (190 mm)
3 / 16
G ˝ (5 mm)
7.2

Mounting instructions

Install Tempra as close as possible to the main hot water draw-
off points.
Install Tempra in a frost free area. If frost might occur, re-
move unit before freezing temperatures set in.
Leave a minimum of 5" (120 mm) of clearance on all sides for
servicing.
F
WWW.STIEBEL-ELTRON-USA.COM
G