Care & Maintenance; Replacement Parts - Ninja NC600CCO Série Guide Du Propriétaire

Assembly and Use of the Pitcher - cont.
USE
Locking Handle
Fig. 5
7 Holding the lid by the handle in the upright
position, place it on top of the pitcher
aligning the arrow ( ) located on the lid
with the arrow ( ) located on the pitcher's
handle (Fig. 5).
8 Plug the power cord into the
electrical outlet.
9 Select the speed according to your
blending requirements*:
• Use the speed 1 button for processing
and mixing.
• Use the speed 2 button for blending
and ice crushing.
• Use the speed 3 button for pureeing
and liquefying.
• Use the pulse button for controlled
chopping and processing.
*See Blending Chart for additional
information.
NOTE: If you need to add additional
ingredients while the blender is processing,
open the pouring spout cap and pour the
ingredients in through the opening.
11 1-877-646-5288
REMOVAL
Fig. 6
Fig. 7
10 Press power button ( ) or the same speed
button a second time to stop the stacked
blade assembly or press a different button
to change the speed.
11 Press the power button ( ) to turn the
appliance off. Wait for the stacked blade
assembly to stop moving before removing
the pitcher (Fig. 6).
12 Open the pour spout cap and use the
spout to empty liquid contents.
For thicker consistencies, first remove
the lid by pressing the release button
and pulling the lid handle up to a 90
degree angle to lift lid off the pitcher.
Then, carefully remove the stacked blade
assembly by the top of the shaft and set
it safely aside. Then empty contents from
the pitcher (Fig. 7).
Care & Maintenance
CLEANING
1
Separate/remove all parts from each other.
2 Hand-Washing: Wash the pitcher, lid, and
stacked blade assembly in warm, soapy
water. When washing the blade assembly,
use a dishwashing utensil with a handle
to avoid direct hand contact with blades.
Handle blade assembly with care to avoid
contact with sharp edges. Rinse and
air-dry thoroughly.
Dishwasher: The pitcher, lid, and
stacked blade assembly are all dishwasher
safe. The lid and blade assembly are
top-rack dishwasher safe. Ensure the
blade assembly is removed from the
pitcher before placing in the dishwasher.
3 Wipe the motor base clean with
a damp cloth.
Please call Customer Service at
1-877-646-5288. if any servicing needs
to be performed on the appliance.
STORING
1
Store the Ninja® Professional Blender
upright with the Stacked Blade Assembly
inside the pitcher with the lid secured on
top. Do not place anything on top. Tuck
power cord in cord storage compartment
in the back of the unit.
ORDERING REPLACEMENT PARTS
To order additional parts and accessories, visit ninjaaccessories.com
or contact Customer Service at 1-877-646-5288.
RESETTING THE MOTOR THERMOSTAT
The Ninja® Professional Blender features
a unique safety system prevents damage
to the unit's motor and drive system should
you inadvertently overload your appliance.
If the appliance is overloaded, the motor
will stop. Allow the appliance to cool for
approximately 15 minutes. To reset the
appliance, follow the resetting procedure
below:
1 Unplug the appliance from the
electrical outlet.
2 Remove and empty the pitcher and
ensure no ingredients are jamming
the stacked blade assembly.
3 Allow the appliance to cool for
approximately 15 minutes.
4 Install the pitcher on the base and plug the
appliance into an electrical outlet.
5 Proceed to use the appliance as
before making sure not to exceed the
recommended maximum capacities.
ninjakitchen.com 12