Operation Tips - Varan VAR-CB-20 Manuel D'utilisation

OPERATION TIPS

• Execute the charge in airy places to avoid gas accumulation.
• Before charging open the cap of each element.
• Check that the level of the internal liquid of the battery covers the plates. On the contrary, add distilled water up
to the max level indicated on the battery.
• Do not touch the liquid inside the battery. It is corrosive.
• Clean the positive and negative terminal of all possible oxidations so as to ensure a good contact of the clamps.
• Avoid the contact between the two clamps when the battery charger is switched "on", if you do the fuse will
burn down.
• If the battery charger is used with a battery which is always connected to a vehicle, check the instruction and /or
maintenance manual of the vehicle under the paragraph, "ELECTRIC PLANT "or "MAINTENANCE". Before
charging it is advisable to disconnect the positive cable which is part of the electrical plant of the vehicle.
• Control/check the battery voltage before connecting it to the battery charger, Remember that 3 caps correspond
to a 6 volt battery, while 6 caps to a 12 volt battery, At times you may have two 12volt batteries which are
connected in series, in this case you need a 24v voltage to charge both accumulators.
• Check the polarity of both clamps: positive "+", negative "-", in case the symbols were not easily recognizable
please remember that the negative clamp is that connected directly to the case / device.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
VAR-CB-20