Varan VAR-CB-20 Manuel D'utilisation page 12

Note: During charging process, the output charging current does not remain constant, it goes down from high amp
to low level as the capacity of battery increasing.
WARNING: LOW OR NO MAINTENANCE OF THE BATTERY.
In case you charge with this kind of battery, stay careful. Charge slowly and keep on checking the voltage at the
battery clamps. When the voltage reaches 14,4/28,8 Volt(this can be easily detected by a normal tester ,) it is
advisable to stop charging .
SIMULTANEOUS CHARGING OF MORE BATTERIES
When more batteries are to be charged at the same time, the parallel or serial connections can be used. Between
the two it is better to use the serial connection as in this way you can check the current passing in each battery
which is the same as the current signed by the ammeter.
NOTE: in case of serial connection of two batteries having nominal voltage 12V, it is recommended to set the 12/24
switch in 24V position.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
VAR-CB-20