Varan VAR-CB-20 Manuel D'utilisation page 13

END OF CHARGE
When charging is completed, first step is to disconnect the mains voltage by turning the switch to off position. And
/or disconnect the mains cable from the mains plug. Then, disconnect the charging clamps from the battery
terminals and put the battery charger in a dry place. Remember to reset the caps of the battery.
PROTECTION
Protect mains line with fuses or automatic switches of the same values as indicated on the device by means of
symbol.
The battery charger is equipped with protection in case of:
• Overloads (too much current delivered towards the battery)
• Short circuit (charging clamps set in contact with one another )
• Polarity reversal of the battery.
For battery chargers equipped with fuses, it is necessary, in case of substitution of fuses , to use spares having the
same nominal current values as the fuse changed .
WARNING:
If fuses with current values different from those given were used, damages to persons and things
could be caused. For the same reason do not substitute the fuse with copper (or other material) bridge. The
substitution of the fuses is to be done when the mains cable is disconnected from the mains power.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040
VAR-CB-20