Important - CBM 2429/V Mode D'emploi

C.B.M. S.r.l. Medical Equipment - Via Castello 10, 26038 Torre dé Picenardi (CR) – Italy
•
(I) (L) keys
The function of these keys is to modify the temperature setting and the incubation time, increasing or
decreasing the value. By pressing the
set temperature value or the set incubation time is visualized on the display.
From this moment, by pressing the
After reaching the desired value, wait 3 seconds for automatic acquisition.
If one of these keys is pressed during the cycle, the set values of time or temperature can be read on the
display but it is not possible to modify them.
•
(M) Heating pilot lamp
This lamp indicates the switching on of the heating elements of the equipment.
1. Connect the plug into the 230V outlet. Switch on the master (A).
The display shows a short self test, including the Firmware Version.
The yellow pilot lamp (B) is turned on in order to show that the machine is ready for the cycle.
2. Open the two sliding chimneys on both sides in order to make an easier air circulation inside the
incubator.
3. Place the material to be treated inside the incubator and close the door (do not open the door during the
cycle).
4. Set the desired temperature and time of incubation,
- Set the temperature :
with the temperature pilot lamp on, press the
increase or the decrease of the value becomes quick. After reaching the desired value, wait 3 seconds
for the storing of the set value.
- Set the incubation time:
press the switch push button
order to visualize and modify the time. Wait 3 seconds for the storing of the set value.
5. After the parameters setting, start the incubation cycle by pressing the "START" push button. The yellow
pilot lamp (B) turns off.
6. After some minute the incubator arrives at the set temperature and keeps it for the set time. The
temperature measured inside the incubation chamber is visualized on the display (with a ± 2° C tolerance)
ó
or, by switching the
7. At the end of the set time, the cycle automatically stops and the display shows the writing END matched
to few BIP sounds, informing that the incubator has finished the cycle.
IMPORTANT: The cycle is considered valid only if, at the end, the writing "End"
appears.
8. At the end of the cycle close the sliding chimney in case some material is left inside.
9. If the equipment is not used, switch off the master (A) or the push button START.
ATTENTION: AT INFINITE TIME THE EQUIPMENT CAN BE SWITCHED OFF ONLY
Rev.3 – 28/07/2010
+
key once, with the incubator waiting (B pilot lamp turned on), the
―
+
or keys it is possible to modify the value.
User's instructions
+
ó
the timer pilot lamp turns on
push button, the remaining time to the end of the cycle.
MANUALLY.
2429-2430-2431-V COMP- r3x4.DOC
―
or keys, or keeping the push button pressed, the
½
. Repeat the previous operations, in
pag. 7 di 17