Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
KITE SERIES
Assembly And Installation
1.
Install CPA115 ceiling plate to ceiling following CPA115
installation instructions.
2.
Making sure holes on KITE Series column (E) and CPA115
mount (A) are aligned, install column onto CPA plate
adapter. (See Figure 1)
3.
Install either one M6x16 button head screw (C) or security
screw (D) into hole on side of CPA pipe where the adapter
plate on CPA adapter is located. (See Figure 1)
4.
On the opposite side of CPA pipe, use the other M6x16
button head screw (C) or security screw (D) to secure RSE
(A) to CPA column. (See Figure 1)
adapter
plate
3
(C) or (D)
Figure 1
WARNING:
Failure to provide adequate support for this
mount during the height adjustment process can result in
serious personal injury or damage to equipment! Height
should be adjusted prior to installing projector to mount!
5.
Loosen height adjustment screw. (See Figure 2)
6.
While supporting the weight of the projector mount, adjust
height as desired. (See Figure 2)
7.
Tighten height adjustment screw. (See Figure 2)
6
1
(A)
2
4
(C) or (D)
6
7
5
height adjustment
screw
Figure 2
Projector Installation
Install Projector With Interface Bracket
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. DO
NOT substitute hardware. Use only the hardware provided by
the manufacturer.
1.
Secure interface bracket to mount using installation
instructions and hardware provided with interface bracket.
NOTE:
Interface brackets can be installed using the optional
All-Points Security Kit included with the SSM mounting
solutions.
1
Figure 3
Installation Instructions
6
Example Only
(Interface bracket
varies dependent
on projector model)
Publicité
Table des Matières
