Package Contents; Before First Use; Parts And Controls; To Use - Beurer GS 226 Mode D'emploi

BATTERY SAFETY PRECAUTIONS
• Use only the size and type of batteries specified.
• Be sure to follow the correct polarity when installing the batteries. Reversed batteries may cause
damage to the device.
• Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh
ones. Always replace batteries as a simultaneous set.
• If the batteries in the device are depleted or the device will not be used for a long period of time, remove
the batteries to prevent damage or injury from possible battery leakage.
• Do not try to recharge batteries not intended to be recharged; they can overheat and rupture
(follow battery manufacturer's directions.)
• Do not dispose of batteries in fire, batteries may explode or leak.
• Clean the battery contacts and also those of the device prior to battery installation.
• Remove discharged batteries from the product and dispose/recycle in compliance with all applicable
laws.
• Keep batteries away from children and pets. Batteries may be harmful if swallowed. Should a child or
pet swallow a battery, seek medical assistance immediately.

Package Contents

• GS 226 glass scale
• 3 x AAA 1.5 V batteries
• instruction manual

2. Before First Use

1. Remove the Battery Compartment Cover located underneath the scale and insert three 'AAA' size batter-
ies (included) according to the polarity markings inside the compartment. Replace Battery Compartment
Cover. When 'Lo' appears in the LED Display, the batteries need to be replaced.
2. Place the scale on a hard, level floor (no carpeting or rugs); a hard surface is required for accurate measurement.

3. Parts and Controls

4. To Use

1. Press the Unit Selector Button, located underneath the scale, to show 'lb' (pounds), 'kg' (kilograms), or
'st' (stones) in the LED Display. Results are shown in increments of 0.2 lb (0.1 kg/0 st : 1 lb)
2. Place the scale on a flat, hard, and level surface to ensure accurate measurement.
3. Carefully step onto the scale.
4. Stand still and distribute your weight evenly on both feet.
5. After a few seconds, the scale will stabilize and your weight will flash on the LED Display. Step off the
scale; the LED Display will shut off after a few seconds.
Unit Selector Button
Battery Compartment
4