Removing Fluff And Dust From The Pre-Filter; Cleaning The Housing; Filter Replacement; Replacing The Pre-Filters - Miele PAC 1045 Mode D'emploi

Replacing the
pre-filters

Removing fluff and dust from the pre-filter

The pre-filters in the plinth of the air purifier prevent dust and fluff
from getting into the air filter during operation of the appliance. In or-
der to optimise operation of the air filter, the soiling that accumulates
in front of the pre-filter must be removed on a weekly basis or as re-
quired.
Remove the plug from the socket and ensure that the air purifier is

de-energised.
Clean the pre-filters through the air intake vents from the outside

using a vacuum cleaner.

Cleaning the housing

Remove the plug from the socket and ensure that the air purifier is

de-energised.
If the appliance was in operation before it was unplugged, wait ap-

prox. 10 minutes to allow it to cool down fully.
The housing may still be warm immediately after operation.
When the air purifier housing has cooled down, clean it with a soft,

damp cleaning cloth. Make sure that you do not touch any electrical
components.
Do not use solvent-based liquid cleaning agents and/or sprays.


Filter replacement

 Risk of fire if washed filters are reused.
Contaminated filters must not be cleaned with solvent-based fluids
and then reused in the air purifier.
Contaminated filters must always be replaced with new ones.
When replacing filters, only use accessory parts approved by
Miele.
If other parts are used, warranty, performance and/or product liabil-
ity claims will be invalidated.
Wear suitable personal protective equipment (e.g. mask, gloves,
goggles) when replacing the filters.
Any filters that have been used and are contaminated with particulate
as well as filters that are potentially toxic and/or contaminated with
pathogens should be placed in a sealable bag immediately after re-
moval from the appliance.
The pre-filters mounted behind the air intake vents must be replaced
roughly every 6–12 months. The pre-filters must be replaced if they
are contaminated or if the suction power is too low. The pre-filters
can be replaced via the service flap at the bottom of the air purifier.
en - Cleaning and care
59